Installation and clamping device for milling of gearbox housing base
- Added: 21.04.2014
- Size: 500 KB
- Downloads: 0
Subscribe to receive an information about new materials:
Description
Design of mounting and clamping device for milling of gearbox housing base. The blank is based in the fixture and clamped by a pneumatic cylinder. The explanatory note gives a full calculation of this device.
Project's Content
|
ТО 28 Пз.doc
|
Установочно-зажимное приспособление.cdw
|
The material is an archive with files that can be opened in programs:
- Microsoft Word
- Kompas or KOMPAS-3D Viewer
Additional information
Contents
Table of contents
1. Design and Graphics Job
2. "Process Design, Installation and Basing"
3. "Calculation of required fixing forces"
4. "Fixture Power Calculation"
List of literature
Drawings content
Установочно-зажимное приспособление.cdw
Similar materials
Free downloading for today
Update after: 9 hours 49 minutes
