Beam cage - Course on metal structures

Contents

Introduction

1. Beam cage layout

2. Structural flooring calculation

3. Calculation of flooring beams

4. Main Beam Calculation

4.1. Define Loads and Design Forces

4.2. Selection of section of rolled beam

4.3. Check of beam strength and deflections

4.4. Calculate Datum Edges

4.5. Calculation of Beam Fillets

5. Column Calculation

5.1. Solid Column Rod Calculation

5.2. Column Base Calculation

5.3. Designing Column Heads

Introduction

The design of the beam cage is designed to consolidate theoretical knowledge of the relevant section of the course and provide the necessary skills in the calculation and design of metal structures.

By the nature of the tasks considered and solved, the course work is divided into two parts: calculation and graphic. In the design part, a version of the beam cage is selected, calculations of the flooring, floor beams, main beams, columns, parts and assemblies are carried out.

In the graphic part, drawings of the beam cage in the CM and CMD stage are compiled. In this part, the following are developed: the installation diagram of the beam cage with the marking of all elements, drawings of the sending marks of the main and auxiliary beams, columns, as well as structural interfaces. A steel specification and a table of shipping marks are compiled.

The initial data of the design task are determined in accordance with the cipher set according to the last and penultimate digits of the score book number.

Cipher 30

Longitudinal pitch of columns: L = 12 m;

Transverse pitch of columns: l = 5 m;

Standard payload: 500 kg/m;

Floor thickness: 3 mm;

Height of columns: 6 m;

Steel brand: C 245;

Foundation concrete class: B10.

Минкина Г.М.МК.dwg