Automation of a comprehensive residential building

General Data

1. Detailed drawings have been developed in accordance with applicable codes, regulations and standards.

2. This album provides for the installation of equipment of an automated lighting and microclimate control system in residential buildings based on EIB/KNX standard equipment.

3. Work shall be carried out in accordance with the requirements of the following documents:

SNiP 2.04.0591 "Heating, ventilation and air conditioning";

Electrical Installation Rules, ed. 7.

SNiP 3.05.0785 "Automation Systems";

GOST 24.10485 "Automated control systems. General requirements ";

GOST 24.10384 "Automated control systems. Basic Provisions ";

GOST 24.70385 "Typical design solutions in ACS. Basic Provisions ";

GOST 34.60392 "Types of tests of automated systems";

GOST 34.60289 "Technical Assignment for the Creation of an Automated System";

GOST 34.60190 "Automated systems. Stages of creation. "

1. Install the shield on the mounting base with height of 100150mm close to the wall. The structure of the base is not fixed in the project and remains at the discretion of the installation organization. After the board is installed on the base, attach it to the wall with the SDWC010 mounting kit.

2. In the drawings, the places of installation of control devices and lamps are shown conventionally. Exact references for installation are determined by the design project. It is also possible to change the collar of lamps in groups.

3. Heating control drives:

FV.1.5.1 - drive responsible for supplying water to the lounge radiator (large radiator near the fireplace)

FV.1.5.2 - drive responsible for water supply to the lounge radiator (small radiator near the fireplace)

FV.1.5.3 - drive responsible for supplying water to the lounge radiator (radiator mounted on the wall opposite the fireplace)

FV.1.2.1 - drive responsible for water supply to the hall radiator

FV.1.6.1 - drive responsible for water supply to the 1st floor bedroom radiator

FV.1.3.1 - drive responsible for water supply to the dining room radiator (separate radiator installed near the wall bordering the living room)

FV.1.3.2 - drive responsible for water supply to the radiators of the dining room (4 radiators)

FV.2.2.1 - drive responsible for water supply to bedroom radiators 2.2

FV.2.3.1 - drive responsible for water supply to bedroom radiators 2.3

FV.242.1 - drive responsible for water supply to bedroom radiators 2.4

4. Lead cable in corrugated pipe D16, D20, D25. The cable exit from the panel, as well as the cable passage on the 1st-2nd floor, shall be made in the metal tray.

5. The number of lamps and their location in groups 5.5, 5.6, 2.1 are not known at the time of design. See the design project.