tractor kinematic diagram and drawings

Contents

Contents

Introduction of ____

ESCS software for CP execution ____

Methodical material for drawing execution ____

Device and operating principle of 2-line clutch ___

Proposed clutch ____

Clutch calculations ____

Conclusion of the ____

Literature

Introduction

Clutches are widely used on modern tractors in various mechanisms. They are installed between the engine and the gearbox, in turning mechanisms, in gearboxes, in drives to take-off shafts, etc.

A properly designed and adjusted coupling, in addition to the general requirements for all mechanisms, shall ensure reliable torque transmission from the drive shaft to the driven shaft in all operating conditions. Cleanliness of shutdown, i.e. rapid and complete separation of friction surfaces; smooth actuation, that is, smooth growth of torque on the driven shaft; good heat sink from rubbing parts; reliable protection of transmission parts from overloads; minimum moment of inertia of driven parts.

Depending on the method of torque transmission from the driving to the driven shaft, clutches are divided into friction clutches - torque is transmitted under the action of friction forces; hydraulic - torque is transmitted by fluid flow energy; electrical - the interaction of electromagnetic fields is used.

The purpose of the course project is to develop a 2-line clutch for a class 0.6 tractor.

KP tasks:

- study CAD Compass

- study clutch designs

- MC design selection

- development of MS design and technical drawings

Conclusion

In this course of the project, the tasks were set for the design of tractor units, namely clutch clutches, modern computer technologies. Especially engineering analysis, parameterization and production of three-dimensional model of clutch and generation of working drawing. Which was done in this work. This study method provides a full-scale design analysis, real-time assembly layout, and automatically edit any design changes that crush design time. Of course, parameters that are obtained by this method are not specific parameters for further design they are a "guide" in which direction to move. And with further design, these data and parameters can change from a technical solution. etc.