• RU
  • icon Waiting For Moderation: 0
Menu

Plate conveyor drive

  • Added: 21.09.2015
  • Size: 855 KB
  • Downloads: 0
Find out how to download this material

Description

Plate conveyor drive. All calculations + 3 of drawing sheet A1: drive, gearbox, working drawings of four parts.

Project's Content

icon
icon 01-01 Лист 1.cdw
icon 01-01 Лист 2.cdw
icon 01-01 Лист 3 Вал.cdw
icon 01-01 Лист 3 Звёздочка.cdw
icon 01-01 Лист 3 Колесо зубчатое.cdw
icon 01-01 Лист 3 Шкив ведомый.cdw
icon 01-01 ПЗ для отправки.doc

Additional information

Contents

1 Initial data

2 Description of the structure

3 Engine selection

4 Kinematic calculation

5 Gearing calculation

6 Calculation of V-belt transmission

7 Calculation of chain transmission

8 Preliminary calculation of gear box shafts

9 Gearbox output shaft calculation

10 Calculation of rolling bearings

11 Calculation of key connections

12 Technical and economic calculations

13 Safety precautions

List of literature

Appendix A - Graphic Material

Appendix B - Specifications

Project Description

The explanatory note contains 45 sheets, 6 figures, 3 sheets of A1 format, 9 sources, 2 annexes.

DRIVE, PLATE CONVEYOR, GEAR WHEEL, MODULE, NUMBER OF TEETH, POWER, SPEED, TORQUE.

The design object is the plate conveyor drive.

The purpose of the work is to design the drive of the plate conveyor.

As a result of the work, a plate conveyor drive was designed.

Technical and economic calculations

Oil for lubrication of the mechanism should be clean, acid-free, should not contain water and solid particles.

It is recommended to use oil of grade "I40A" GOST 2079975.

During operation of the mechanism, oil is sprayed with rapidly rotating gears, due to which it falls on all working surfaces of the reduction gear box.

Plastic lubricant is put into bearing assemblies, which is prevented from flowing out by retaining rings.

Oil replacement should be performed for the first time after 1215 days, for the second time - after 2025 days, then once every 3 months. Oil is lowered through the drain hole provided in the reduction gear box housing.

When changing oil, the mechanisms must be washed with pure kerosene. Before filling oil should be filtered.

Drawings content

icon 01-01 Лист 1.cdw

01-01 Лист 1.cdw

icon 01-01 Лист 2.cdw

01-01 Лист 2.cdw

icon 01-01 Лист 3 Вал.cdw

01-01 Лист 3 Вал.cdw

icon 01-01 Лист 3 Звёздочка.cdw

01-01 Лист 3 Звёздочка.cdw

icon 01-01 Лист 3 Колесо зубчатое.cdw

01-01 Лист 3 Колесо зубчатое.cdw

icon 01-01 Лист 3 Шкив ведомый.cdw

01-01 Лист 3 Шкив ведомый.cdw
up Up