Intermediate shaft - Diploma thesis
- Added: 28.02.2024
- Size: 1 MB
- Downloads: 2
Description
Content
Introduction
1. Analysis of initial data
- Description of the design and service purpose of the part..............2
- Determination of the type of production and its characteristics.................. 7
- Part Manufacturability Analysis
Technical sketch............................................................... 10
- Development of part processing technology
- Recommendations for the development of a design technological process
- Basic Process Analysis.............................. 10
- Selection of the type and justification of the method of obtaining the workpiece
- Description of the method of obtaining the workpiece.................................... 15
- Determination of tolerances for the dimensions of the workpiece, allowances for mechanical treatment of surfaces according to
- Recommendations for the development of a design technological process
transitions, calculation of the dimensions and weight of the workpiece.......................................... 19
- Development of the project technological process
- Creation of a processing sequence for the designed technological process.................................................................. 21
- Selection and Justification of Technological Bases...............................29
- Dimensional Analysis..............................................................30
- Selection of equipment and tooling
Operational Process Development............................32
- Determination of cutting data for the operations to be designed. Summary Table of Cutting Data......................................................................... 36
- Standardization of designed operations. Summary Table of Time Norms........................................................................................... 37
- Energy and resource saving measures........................ 43
- Comparative characteristics of the basic and design variants of the technological process............................................................ 46
Conclusion................................................................................................... 47
Bibliography...................................................................................48
Project's Content
|
|
Пояснилка.docx
|
|
СОДЕРЖАНИЕ.docx
|
|
|
КЭ 010.frw
|
|
КЭ 015.frw
|
|
КЭ 020.frw
|
|
КЭ 025.frw
|
|
КЭ 030.frw
|
Тех процесс.doc
|
|
Титулка.docx
|
|
Титульные на комплект технологических документов.doc
|
|
|
Вал заготовка.cdw
|
|
Вал.cdw
|
|
колибр скоба.cdw
|
|
Приспособление.cdw
|
|
Размерный анализ.cdw
|
|
Режущий инструмент.cdw
|
Технологическая наладка _ КП-1014000-2020.cdw
|
|
Технологическая наладка _2.cdw
|
|
Технологическая наладка _3.cdw
|
|
Технологическая наладка _4.cdw
|
Additional information
КЭ 010.frw
КЭ 015.frw
КЭ 020.frw
КЭ 025.frw
КЭ 030.frw
Вал заготовка.cdw
Вал.cdw
колибр скоба.cdw
Приспособление.cdw
Размерный анализ.cdw
Режущий инструмент.cdw
Технологическая наладка _ КП-1014000-2020.cdw
Технологическая наладка _2.cdw
Технологическая наладка _3.cdw
Технологическая наладка _4.cdw
