Design and calculation of hydraulic press for 10t
- Added: 09.07.2014
- Size: 1 MB
- Downloads: 4
Description
Project's Content
|
|
Записка.docx
|
мой черт готов.bak
|
мой черт готов.cdw
|
наконечник.cdw
|
Спецификация.spw
|
Additional information
Contents
. Design Description and Operating Principle
1.1. Introduction
1.2. Hydraulic Press Design and Operation
1.3. NORDBERG Hydraulic Press Line
1.4. Spring compressors
1.5. Selecting a Design Object
1.6. Winch Selection
2. Calculations
2.1. Calculation of the working area of the main cylinder
2.2. Calculation of liquid volume required for full extension of working cylinder rod
2.3. Determination of number of rockers for full rod extension
2.4. Table Calculation
2.5. Top Beam Calculation
2.6. Calculation of spring compressor upper legs
2.7. Calculation of Hinge Pins
List of literature used
Introduction.
The press mechanism is designed to perform such operations as bending, compression of materials, pressing/cutting of bearings, repair of the suspension, and many other actions during repair. Wedge, screw, lever, as well as hydraulic presses are distinguished. Hydraulic presses have become widespread due to the possibility of creating large efforts at small sizes. The hydraulic press can be structurally made in various versions - floor or table and can vary depending on the model in terms of size, weight and degree of force applied.
мой черт готов.cdw
наконечник.cdw
Спецификация.spw
Similar materials
Free downloading for today
- 21.04.2016