Description of development of manufacturing process of aircraft gear part

Contents

Table of contents

1. Development of the assembly process

1.1. Analysis of assembly specifications, identification of main process tasks, development of control diagrams for main parameters

1.2. Comparative analysis of the processability of the assembly design for two types of production: large-scale and small-scale; evaluation criteria

1.3. Substantiation of methods to achieve required assembly accuracy

1.4. Development of process diagrams of assembly and general assembly,

necessary justifications

1.5 Preparation of the process of assembly of the assembly (with sketches on transitions): rationing, selection of equipment and special actuators

2. Part Manufacturing Process Route Design

2.1. Analysis of the part fabrication specification, identification of the main technological tasks: development of control diagrams for the main accuracy parameters

2.2. Comparative analysis of workability of a part design for two types of production (large-scale and small-scale)

2.3. Main Surface Route Selection, Comparative Justification for Two Types of Production

2.4. Selection of layouts of workpieces installation (basing and fixing) and their analysis for all route operations

2.5. Development of process routes of part manufacturing for two types of production: design of operation sketches with reference designations of basing elements and fixation of workpieces, selection of equipment

2.6. Issuing roadmaps

List of literature used

Деталь крупносерийное.cdw

Деталь мелкосерийное.cdw

Сборка.cdw