Expansion of the technological capabilities of the CNC machine on the basis of modernization of the control system, adopting the TP500F3 lathe as a prototype
- Added: 21.10.2023
- Size: 804 KB
- Downloads: 1
Description
Introduction
1 Analysis of machine kinematics and justification of the type and number of controlled and controlled parameters
2 Rationale for the direction of modernization
3 Rationale for the selection of the CNC system series and clarification of the functional scheme
4 Development of electrical schematic diagrams of interface of automation and CNC elements
5 Development of a scheme for connecting the CNC system with external devices and connecting the actuators of the machine
6 Description of the procedure for characterizing additional functions that have arisen during the modernization of the machine for the CNC system
7 Development of electrical schematic diagrams of the measuring unit controlled for the purpose of adaptation of the parameter
8 Developing an algorithm block diagram for one of the interpolation loops
Conclusion
References
Project's Content
|
|
Блок-схема.cdw
|
|
Кинематическая схема.cdw
|
КП.docx
|
|
Схема УЧПУ NC-300.cdw
|
|
Эл схема.cdw
|
Additional information
Блок-схема.cdw
Кинематическая схема.cdw
Схема УЧПУ NC-300.cdw
Эл схема.cdw
Similar materials
- 25.01.2023
