• RU
  • icon Waiting For Moderation: 0
Menu

Accessory for measuring geometry of ICE crankshaft journals.

  • Added: 03.05.2015
  • Size: 231 KB
  • Downloads: 4
Find out how to download this material

Description

Accessory is intended for measurement of geometry of crankshaft journals of internal combustion engine . Axle (4) is screwed into base (2) by means of screw (3). Rack mechanism (1) consists of: housing (5), gripper (15), axle (8), clamp (13) and adjusting screw (9). After installation of controlled part on mandrel (setting pin), indicator (17) is brought to the part. The indicator rack is rotated so that the indicator (17) fixed on it assumes horizontal position. The indicator must touch the surface of the monitored part and then be fixed with a clamping screw (12). Indicator tip is installed on side surface of neck, and indicator is set to zero. In case of deviation from the roundness, the indicator arrow receives the angular movement indicated by the indicator . The accessory is ready to take readings . To remove the geometry of the crankshaft journals, use the wheel to slowly rotate the monitored part. The necessary readings were taken.

Project's Content

icon
icon
icon
icon Деталировка приспособления .frw
icon Сборочный чертеж.cdw
icon Сборочный чертеж.cdw.bak
icon Спецификация .spw
icon Геометрия шеек коленвала деталировка.frw
icon Геометрия шеек коленвала Сбор черт.frw
icon Описание.docx
icon Спецификация .spw
icon Спецификация .spw.bak
icon Спецификация 210.spw

Additional information

Design Part

Accessory is intended for measurement of geometry of crankshaft journals of internal combustion engine.

Axle (4) is screwed into base (2) by means of screw (3). Rack mechanism (1) consists of: housing (5), grip (15), axle (8), clamp (13) and adjusting screw (9)

After installation of the controlled part on the mandrel (setting pin), the indicator (17) is supplied to the part. The indicator rack is rotated so that the indicator (17) fixed on it assumes horizontal position. The indicator must touch the surface of the monitored part and then be fixed with a clamping screw (12).

Indicator tip is installed on side surface of neck, and indicator is set to zero. In case of deviation from the roundness, the indicator arrow receives the angular movement indicated by the indicator.

The accessory is ready to take readings.

To remove the geometry of the crankshaft journals, use the wheel to slowly rotate the monitored part.

The necessary readings were taken.

Drawings content

icon Деталировка приспособления .frw

Деталировка приспособления .frw

icon Сборочный чертеж.cdw

Сборочный чертеж.cdw

icon Спецификация .spw

Спецификация .spw

icon Геометрия шеек коленвала деталировка.frw

Геометрия шеек коленвала деталировка.frw

icon Геометрия шеек коленвала Сбор черт.frw

Геометрия шеек коленвала Сбор черт.frw

icon Спецификация .spw

Спецификация .spw

icon Спецификация 210.spw

Спецификация 210.spw
up Up