Metrology coursework
- Added: 29.04.2021
- Size: 668 KB
- Downloads: 0
Description
Note, drawing "gearwheel assembly," drawing "gearbox drive"
Project's Content
Privod_reduktora.cdw
|
zapiska.doc
|
|
Koleso_zubchatoe_Sborochnoe.cdw
|
Additional information
Contents
CONTENTS
Calculation and selection of fits for smooth cylindrical joints
Calculation and selection of fits for plain bearings
Theoretical calculation and selection of interference fits
Selection of fits for splined straight-flow joints
Selection of gear wheel parameters monitoring systems
Calculation of the dimension chain by full interchangeability
Literature
Gearbox drive
From the shaft installed in the rolling bearing 18, rotational motion is transmitted through the half-couplings 6 and 7 to the shaft 8. Shaft 8 is installed in sliding bearings 9 and 16. From the shaft 8, motion is transmitted through a fixed spline joint to the gear unit 12 and 13.
Privod_reduktora.cdw
Koleso_zubchatoe_Sborochnoe.cdw
Similar materials
Free downloading for today
Other materials
- 29.08.2014
