Development of the technological process for the production of the "Glass" part
- Added: 29.03.2024
- Size: 2 MB
- Downloads: 2
Description
Introduction..................................................................................................................... |
1 Main body.............................................................................. |
1.1 Description of the design and drawing of the part .......................................... |
1.2 Part manufacturability analysis...................................................... |
1.2.1 Part Drawing Analysis................................................................. 1.2.2 Qualitative analysis of the manufacturability of the part design................. |
1.2.3 Quantitative analysis of part manufacturability................................ |
1.3 Determination of the type of production........................................................ |
2 Technological part...................................................................... |
2.1 Selection of the method of obtaining the workpiece..................................................... |
2.2 Treatment plan for individual surfaces of the part ................................. |
2.3 Development of a processing route for the manufacture of the "Pulley" part................ |
2.4 Selection of technological bases............................................................ |
2.5 Selection of technological equipment .............................................. 2.6 Selection of Machine Tools .................................................... |
2.7 Determination of inter-operational allowances, tolerances and dimensions Workpiece....................................................................................... |
2.7.1 Determination of inter-operational allowances, total allowances and operational dimensions on the treated surface by the computational and analytical method for determining allowances (RAMOP)............................................ |
2.7.2 Determination of inter-operational allowances, general allowances and operational dimensions by static method................................................... |
2.8 Means of technical control of product quality............................ |
2.9 Establishment of .................................................... processing modes |
2.9.1 Calculation and assignment of cutting data by analytical method.............. |
2.9.2 Calculation and assignment of cutting data by static method................. |
2.10 Technical standardization............................................................ |
Conclusion..................................................................................... |
References...................................................... |
Regulatory References......................................................................... |
Appendix A – Manufacturing Process of the Pulley Part...... |
Project's Content
3_KN20-5.cdw
|
PZ_TM_Peshekhonova.docm
|
KN035.cdw
|
2_otlivka-2_Shkiv-5.cdw
|
1_Detal_-_Shkiv_-5V.cdw
|
Additional information
3_KN20-5.cdw
KN035.cdw
2_otlivka-2_Shkiv-5.cdw
1_Detal_-_Shkiv_-5V.cdw
Similar materials
- 13.12.2022
- 24.01.2023
- 13.03.2024
- 24.01.2023