Coursework Design of STO maintenance area
- Added: 23.05.2016
- Size: 398 KB
- Downloads: 4
Description
In this course project, the annual production program for repairing the MAZ 5336 car is calculated. The maintenance area was planned. Provided those card "Repair of car spring" Completed drawing of accessory "Portable riveting plant" Design composition: Note 3 drawing 3 specification
Project's Content
|
|
Пояснительная записка.doc
|
Содержание.doc
|
|
Михновец леша тех карта.kdw.bak
|
Планировка до реконструкции.cdw.bak
|
Планировка участка ТР.cdw
|
приспособление.cdw
|
приспособление.cdw.bak
|
|
Спецификация планировка.doc
|
Спецификация ПО КУРСАЧУ.doc
|
Спецификация приспособление.doc
|
Тех карта Ремонт рессоры.kdw
|
Additional information
Contents
Contents
Introduction of ____________________________________________________
1 General part of the __________________________________________________
2 Process part of the designed enterprise ________________
2.1 Initial data for calculation of _________________________________
2.2. Calculation of annual production program of maintenance and maintenance ____________
2.2.1 Correction of maintenance frequency and mileage to CG ________
2.2.2 Calculation of annual mileage of cars ______________________
2.2.3 Calculation of the annual production program _______________
2.2.4 Calculation of daily production program ____________
2.3 Calculation of annual scope of work _______________________________
2.3.1 Correction of maintenance and maintenance labor intensity __________________
2.3.2 Calculation of annual scope of work for maintenance, maintenance and self-service
2.4 Calculation of the number of production workers ________________
3 Production department design _________________
3.1 Process in Division ____________________
3.2 Selection of process equipment _______________________
3.3 Calculation of production area ____________________________
3.4 Subdivision Layout __________________________________
4 Organization of production ______________________________________
4.1 Organization of enterprise management ______________________
4.2 Distribution of workers by specialties, qualifications and workplaces _____________________________________________________________
4.3 Preparation of Job Instruction __________________________
5 Design part _________________________________________
5.1 Purpose and scope of the accessory ______________
5.2 Principle of operation of the accessory ___________________________
5.3 Calculation of the accessory _____________________________________
Conclusion of the ____________________________________________________
List of used _____________________________ sources
Introduction
The task of road transport is to meet the need for transportation within the specified time frame and in the required amount. To solve it, it requires vehicles of a certain type and a production base that provides their storage, maintenance and repair.
Course design is an important stage of the subject "Technical operation of cars" and has the following goals and objectives:
consolidation, improvement and replenishment of knowledge and skills gained in the process of training, in the organization of production, technology of maintenance and repair of cars, design of production zones and sections;
increasing knowledge of scientific organization of labor and design of motor transport enterprises;
Training in best production practices and skills in diagnosis, maintenance and maintenance of vehicles;
selection and analysis of materials of technological and design nature necessary for the performance of the diploma project;
developing the ability to analyze and logically justify engineering decisions.
Implementation of the project develops ability to independently solve technological and design problems, ability to use standards, standards, reference and other special books.
Планировка участка ТР.cdw
приспособление.cdw
Similar materials
- 04.11.2022
- 12.10.2016
- 24.05.2016