Conical single-stage reducer with horizontal slow-moving shaft u = 9
- Added: 07.06.2020
- Size: 1 MB
- Downloads: 2
Description
Course project on "Calculation of belt conveyor drive with structural development of conical gear box." Job inside the jpeg archive.
Project's Content
|
Сборочный чертеж Конический редуктор.cdw
|
Спецификация на СБ.spw
|
ДеталировкаСтакан.cdw
|
Деталировка Шестерня с таблицей.cdw
|
Деталировка Вал тихоходный.cdw
|
Деталировка Зубчатое колесо.cdw
|
Титульный лист.docx
|
Пояснительная Детали машин.docx
|
Задание.jpg
|
Additional information
Contents
Contents
Drive Setup and Diagram
Introduction
1. Kinematic calculation of the drive
2. Gearing Calculation
3. Gearbox Layout
3.1. Shafts
3.2. Bearings
3.3. Gear and Housing Parameters
4. Calculation of key connections
5.Bolt connection calculation
Conclusion
List of literature
Application
Introduction
The course project on machine parts is the first design work of the student, carried out on the basis of the knowledge of general education, general technical and generally special disciplines.
In this course design, it is necessary to develop a chain conveyor drive according to the given scheme. It includes electric motor connected by V-belt transmission to high-speed shaft of cylindrical single-stage reduction gear. Chain conveyor sprocket is arranged on low-speed shaft of reduction gear.
The drive is designed on the basis of the specification. It is necessary to develop a gearbox assembly drawing with specification, working drawings of the main parts of the gearbox, as well as to issue a calculation and explanatory note.
Conclusion
In this course design, a belt conveyor drive is designed, consisting of an electric motor connected by chain transmission to the high-speed shaft of a conical reduction gear. Compensating clutch connects high-speed gear shaft with electric motor. Kinematic calculation was made, engine was selected, conical gear was calculated, shafts, reduction gear box housing were designed, bearings were selected. Conical gear and keys were tested for strength.
The gearbox assembly drawing with the specification, as well as the working drawings of the main parts of the gearbox are made.
Сборочный чертеж Конический редуктор.cdw
Спецификация на СБ.spw
ДеталировкаСтакан.cdw
Деталировка Шестерня с таблицей.cdw
Деталировка Вал тихоходный.cdw
Деталировка Зубчатое колесо.cdw
Similar materials
- 24.01.2023
- 26.05.2022
Free downloading for today
Other materials
- 17.04.2023