Calculation and development of the technological process for the manufacture of the brake disc of the GAZ-33021 car

Calculation and development of the manufacturing process
brake disc of car GAZ-33021
A disc brake is a type of brake that uses calipers to
pressing pairs of pads against a disc or "rotor" to create friction. This is
the action slows down the rotation of a shaft, such as the axle of a vehicle,
either to reduce its rotational velocity or to keep it in
stationary. The energy of motion is converted into outgoing energy
heat that needs to be dissipated.
Hydraulically driven disc brakes are the most
a commonly used form of brake for automobiles. However,
The principles of the disc brake are applicable to almost any
rotating shaft. Components include a disc, master cylinder, and
calipers, which contain at least one cylinder and two brake cylinders
pads on both sides of the disc.
Flow:
Operation 005 Procurement
Operation 010 Lathe 8
Spindle p/a mod. 1K-282
Operation 015 Diamond Boring Diamond Boring Mod. 2A-715
Operation 020 Drilling Special Vertical-
Drilling 26-spindle
with seven-position rotary table MH25L
Operation 025 Grinding Vertical Grinding Mod.
M7240
Operation 030 Flying Control Controller Table
Operation 035 Acceptance Inspection Inspector's Table
Maximum diameter 280 mm
Smallest-104mm
Holes-8