TECHNOLOGICAL PROCESS OF MANUFACTURING THE SHAFT PART
- Added: 07.04.2024
- Size: 6 MB
- Downloads: 3
Description
Introduction.............................................................................. 3
- Analysis of initial data...................................................... 4
- Part Drawing Analysis...................................................... 4
- Determination of the volume of output............................................. 4
- Evaluation of manufacturability in terms of machining......................................................................5
- Formulation of technological objectives...............................7
- Determination of the part class and selection as an analogue of the current standard technological process........................................9
- Selection of the initial workpiece and methods of its manufacture.................. 10
- Selection of the workpiece based on the results of the CMM calculation........................ 10
- Final selection of a workpiece based on the results of its cost calculation, taking into account roughing................................12
- Individual Surface Treatment Plan...................................16
- Technological route of the part manufacturing........................... 18
- Selection of Technology Bases.....................................................19
- Designing the entire manufacturing route of the part................20
- Process Operations Design................................25
- Selection of equipment, fixtures, measuring and cutting tools..................................................................... 25
- Calculation of cutting data for one technological transition and assignment of cutting data according to standards for other transitions........................................................................ 28
- Calculation of Time Rates for Operations.........................................31
- Preparation of technological documentation.............................. 34
Conclusion.............................................................................35
References...................................................................
Project's Content
КЭ 055-2.frw
|
КЭ 015.frw
|
val-pravyy.jpg
|
КЭ 065-2.frw
|
КЭ 040-2.frw
|
КЭ 025-2.frw
|
КЭ 040-1.frw.bak
|
val-pravyy.cdw
|
КЭ 065-1.frw
|
КЭ 020-2.frw
|
КПТМ.docx
|
КЭ 065-3.frw
|
КЭ 050-2.frw
|
КЭ 055-1.frw
|
ТП Вал.xlsx
|
КЭ 030-1.frw
|
КЭ 020-2.frw.bak
|
КЭ 040-1.frw
|
КЭ 025-1.frw
|
Карта контроля.xlsx
|
КЭ 050-1.frw
|
КЭ 035.frw
|
Заготовка Вал.cdw
|
КЭ 020-1.frw
|
КЭ 030-2.frw
|
Additional information
КЭ 055-2.frw
КЭ 015.frw
КЭ 065-2.frw
КЭ 040-2.frw
КЭ 025-2.frw
val-pravyy.cdw
КЭ 065-1.frw
КЭ 020-2.frw
КЭ 065-3.frw
КЭ 050-2.frw
КЭ 055-1.frw
КЭ 030-1.frw
КЭ 040-1.frw
КЭ 025-1.frw
КЭ 050-1.frw
КЭ 035.frw
Заготовка Вал.cdw
КЭ 020-1.frw
КЭ 030-2.frw
Similar materials
- 13.12.2022
- 31.01.2023
- 24.01.2023