Structural design presents a bench for checking and repairing plunger pairs
- Added: 15.02.2021
- Size: 399 KB
- Downloads: 4
Description
This device allows you to check the condition of precision plunger pairs of TNVD. To this end, the device adapter is connected to the high-pressure fuel line of the tested section, the full fuel supply is switched on, the engine crankshaft is rotated with a starter, and the pressure generated by the plunger pair of the tested section is determined using the pressure gauge of the device.
The obtained data are compared with the standard. Then, without disconnecting the device from the HPLC section, it is possible to check the condition (tightness) of the pressure valve of the section when the engine is not operating, but the fuel supply is turned on. Using lever-handle of the device create pressure of 0.15-0.20 MPa (150-200 kgf/cm2) - the valve must not pass fuel for 30 seconds (pressure must not drop).
Project's Content
Усков 1.1cdw.cdw
|
|
61 Лист- Стенд А1.cdw
|
|
Усков 3.1cdw.cdw
|
|
Усков 2.1cdw.cdw
|
Additional information
Усков 1.1cdw.cdw
61 Лист- Стенд А1.cdw
Усков 3.1cdw.cdw
Усков 2.1cdw.cdw
