Metal cutting stand (guillotine)

Purpose and short description of the accessory

Bench is intended for metal cutting (billets manufacturing). Stationary bench with working member pneumatic drive. The stand cutting knife is made of 6XB2C steel, which has high wear resistance, high viscosity and is used in the manufacture of knives for cutting metal on any shears with a mechanical, hydraulic and pneumatic drive. Made of 6XV2C steel, knives for guillotines and knives for scissors are used to cut metal of ordinary steel grades with a thickness of 1 to 32 mm.

Characteristics:

Overall dimensions, mm - 590x470x518 (excluding support)

Weight, kg - 160

Type - Stationary

Drive - Pneumatic

Pressure in the drive, MPa - 15

Description of accessory device

Base of stand is frame 1 to which two plates 4 are attached. These plates are the base for the six rolls 11 on which the metal sheet moves during operation. Rolls 11 rotate on axles 7 with bearings 21. This structure is installed in the roll rack 2.

The bench blade 6 is moved in guides 8 which have limiters 9 to prevent possible displacement of the knife in the guides. Knife 6 has clamp 3 which is connected to rod of pneumatic cylinder 23.

The blade is returned to its original position by springs 22.

Pneumatic cylinder 23 is installed on upper plate 10 of frame 1. In addition, braces 5 are provided in the bed to enhance the overall rigidity of the structure.

Design Operation and Maintenance Rules

Persons who have undergone safety training and have studied methods of working with cutting and cutting metal are allowed to work with the device.

The metal sheet shall not exceed 300 mm in width. Chopping is performed by actuation of pneumatic cylinder.

When working, exclude the ingress of hands, clothing and other elements into the knife work area.

It is forbidden to turn on the pneumatic cylinder in case of unreliable installation of metal sheet in the bench.