• RU
  • icon Waiting For Moderation: 0
Menu

Exchange rate VTI - dimensional analysis of the assembly unit

  • Added: 10.01.2015
  • Size: 1 MB
  • Downloads: 1
Find out how to download this material

Description

Coursework in the discipline of VSTI

in this exchange rate, a dimensional analysis of the assembly unit is carried out

Project's Content

icon
icon
icon вал-шестерня.cdw
icon ВСТИ1.bak
icon ВСТИ1.cdw
icon КУРСОВОЙ_ПРОЕКТ_ВСТИ - копия.docx
icon КУРСОВОЙ_ПРОЕКТ_ВСТИ.doc
icon поля допусков.bak
icon поля допусков.cdw
icon ПРОБКА.cdw
icon СКОБА.cdw
icon Спецификация лист.cdw
icon Спецификация моя.bak
icon Спецификация моя.cdw
icon Узел.cdw

Additional information

Contents

Introduction

1. Description of assembly unit

2. Analysis of smooth cylindrical joints

3. Calculation of rolling bearing fits

4. Calculation of gauge tolerance fields

5. Calculation of dimension chains

6. Defining Fits for Key Threaded Connections

7. Selection of universal measuring instruments

Conclusions

List of used literature

Introduction

In modern engineering, it is of great importance to organize the development and production of machines and mechanisms on the basis of interchangeability, creation and use of reliable measurement and control tools.

The interchangeability of products (machines, devices, mechanisms) is their ability to equally replace when using any of the great many copies of products, their parts or other products with other equivalent copies.

Meeting the accuracy requirements for parts and assemblies is an important requirement for interchangeability. Therefore, meeting the specified part requirements is a prerequisite for solving the assembly task of designing and designing mechanisms. The tools and methods of its solution may know the future designer.

Description of assembly unit

This unit is part of a two-stage cylindrical reduction gear box. This assembly is assembled in the following sequence: radial roller bearings 7 are installed on the shaft-gear 1. Then this structure is fixed in the detachable housing 10, one of the bearings is fixed by a washer and a remote ring 4. The ring in turn is clamped by a blind cover 3. On the other side the bearing is fixed by clutch 9, and between it and the ring there is an adjustment gap. The ring is clamped by an end cap 2 with an opening for the cuff seal 8. Gasket 5 is installed between covers and housing before fixation.

Drawings content

icon вал-шестерня.cdw

вал-шестерня.cdw

icon ВСТИ1.cdw

ВСТИ1.cdw

icon поля допусков.cdw

поля допусков.cdw

icon ПРОБКА.cdw

ПРОБКА.cdw

icon СКОБА.cdw

СКОБА.cdw

icon Спецификация лист.cdw

Спецификация лист.cdw

icon Спецификация моя.cdw

Спецификация моя.cdw

icon Узел.cdw

Узел.cdw
up Up