Drying chamber SPM-2k
- Added: 10.05.2016
- Size: 68 KB
- Downloads: 3
Description
According to the technical documentation developed by Hyprodrevprom, since 1979 a steam metal two-chamber dryer of the SPM-2K type has been produced at the Izhevsk Experimental Mechanical Plant of the USSR Minlesprom, similar in principle and purpose to the SPLK-2 chamber. The dryer is a separate building designed to be located on an open area and consists of two periodic chambers heated by the control corridor and laboratory (Figure 4.5). The chambers included in the SPM-2K dryer can be installed inside the heated production room. In this case, the control corridor, lab, and roof panel elements are not included. Enclosing structures of control corridor and laboratory are made in the form of load-bearing wall and roof panels. Three-layer panels with a frame of cold-bent profiles and insulation from semi-rigid mineral wool plates. On the inside the panels are sheathed with flat aluminum sheets or stainless steel sheets, on the outside the wall panels are sheathed with corrugated aluminum sheets, and the coating panels are sheathed with flat steel sheets.
Project's Content
kamera_spm_2k.cdw
|
Additional information
kamera_spm_2k.cdw
Similar materials
- 24.01.2023
