Drawings T-130 Ripper

Contents

Contents

Introduction

1. Design Review and Analysis

2. Calculations

2.1Basic parameters of the ripper

2.2Define clutch force

2.3Define resistance arising during operation of the ripper

2.4Yag calculation

2.5 Check

3. Calculation of tooth strength

4.Performance of hinged ripper

Conclusion

List of used literature

Conclusion

When loosening soils of category IV, it is advisable to organize the work of the machines according to a shuttle and longitudinal-transverse scheme, since they provide the highest performance of the machine. The latter scheme is used when it is necessary to obtain loose rock of smaller size. It is additionally crushed by tractor caterpillars. Soils are loosened at tractor working gear. At the end of the working cycle, the ripper is deepened and the presence of a removable tip is checked. If the tip is lost, you can damage the toe of the post and it will not hold the tip. In this case, the rack is replaced.