DEVELOPMENT OF THE TECHNOLOGICAL PROCESS OF MACHINING PARTS COVER
- Added: 08.06.2023
- Size: 980 KB
- Downloads: 0
Description
Content
INTRODUCTION.................................................................................................................................... 3
1 PURPOSE AND DESIGN OF THE PART................................................................................. 4
2 ANALYSIS OF THE MANUFACTURABILITY OF THE PART DESIGN................................................................................................ 6
3 DETERMINATION OF THE TYPE OF PRODUCTION................................................................................ 10
4 CHOOSING THE METHOD OF OBTAINING THE WORKPIECE................................................................ 11
5 DEVELOPMENT OF THE ROUTE TECHNOLOGICAL PROCESS................ 13
6 CALCULATION OF SURFACE TREATMENT ALLOWANCES................................................ 17
7 CALCULATION OF CUTTING CONDITIONS................. 21
7.1 CALCULATION OF CUTTING CONDITIONS BY ANALYTICAL METHOD................................................................ 21
7.2 CALCULATION OF CUTTING CONDITIONS ACCORDING TO STANDARDS................ 25
REFERENCES.................................... 28
Project's Content
|
|
КП Тех маш.docx
|
Крышка.cdw
|
Крышка.pdf
|
|
Заготовка.cdw
|
|
Заготовка.pdf
|
|
Карта наладки.cdw
|
|
Карта наладки.pdf
|
Additional information
Крышка.cdw
Заготовка.cdw
Карта наладки.cdw
