Development of the technological process for the manufacture of a part - drive gear wheel
- Added: 20.03.2019
- Size: 434 KB
- Downloads: 0
Description
Course project "Development of the technological process for the manufacture of a part - gear drive wheel"
CONTENT
Introduction
Purpose, main characteristics and designs of the sub-assembly
Enumerating Components and Their Assignment in a Subassembly
How the sub-assembly works
Work Part, Purpose and Principle of Operation of the Part in the Subassembly
Analysis of the manufacturability of the design of the working part
Defining the Production Type
Choosing a Method for Receiving a Workpiece
Justification of the technological route
Selection of Process Equipment
Development of basing schemes by operations and selection of fixture
Standardization of material consumption of production
Rationing of labor intensity of production
Title Page
Route and operational maps
Sketch Arts
Assembly drawing of the subassembly
Working Part Drawing
Process Diagram
Operation Charts
Project's Content
|
|
Записка
|
КЭ МАЛЬКО ПЕЧАТЬ.docx
|
|
МК МАЛЬКО ПЕЧАТЬ.docx
|
операционные эскизы А1.cdw
|
спецификация.pdf
|
|
Схема маршрутного тех.процесса А1.cdw
|
|
Чертеж детали А3.cdw
|
Additional information
операционные эскизы А1.cdw
Схема маршрутного тех.процесса А1.cdw
Чертеж детали А3.cdw
