Development of the technological process for manufacturing the part "Drive shaft A1-FN-ZK.01.005"

Coursework on the subject “Mechanical Engineering Technology”

Contents of the explanatory note:

Introduction

1 DEVELOPMENT OF THE TECHNOLOGICAL PROCESS

1.1 Part design

1.2 Determination of the production type

1.3 Analysis of the manufacturability of the part

1.4 Selection of the blank and the method of its manufacture

1.5 Selection of technological bases and basing schemes

1.6 Selection of methods for processing the surface of the part

1.7 Selection of the technological route option and development of technological operations (equipment, tooling, cutting tool)

1.8 Calculation of allowances

1.9 Calculation of cutting modes

1.10 Standardization of operations

1.11 Determination of the required amount of equipment, equipment loading schedule.

1.12 Refined calculation of the production type (by the coefficient of fixing operations)

2 CALCULATION AND DESIGN OF TECHNOLOGICAL EQUIPMENT

2.1 Description and calculation of the control device for control of the tolerance of radial runout of 0.03 mm.

Archive contents: Drawing of the part, operational sketches 2 sheets, drawing of the forging, assembly drawing of the control device. All drawings are in A1 format. Explanatory note, design documentation, route maps, operational sketches.