"Development of the route technological process for manufacturing the part 'Cylinder Rod'" Course Project

Course project "Development of the route technological process for manufacturing the part 'Cylinder Rod'. 3rd year (TM - Engineering Technology) 2024

1- Graphic part

1.1. Working drawing  

1.2. Sequence of machining  

1.3. Operational sketches of machining

2- Explanatory note  

Introduction.

1. General part.

1.1. Initial data.

1.2. Description of the part's design.

1.3. Analysis of the drawing and technical requirements of the part.

1.4. Analysis of the manufacturability of the part's design.

2. Technological part.

2.1. Determination of the type and form of production organization.

2.2. Selection of the design and methods for obtaining the blank.

2.3. Selection of surface machining methods and technological bases.

2.4. Development of the technological route for manufacturing the part.

2.5. Selection of machine equipment.

2.6. Calculation and selection of allowances for surface machining.

2.7. Technical standardization.

2.8. Economic comparison of machining options.

Conclusion.

List of references.

The work was assessed at 10 out of 10 points. All stages of development were completed individually, taking into account the strict requirements of the instructor.