Design of conveyor drive.
- Added: 13.04.2016
- Size: 589 KB
- Downloads: 0
Description
Course project on machine parts. Design of conveyor drive.
Project's Content
|
|
321.cdw
|
вал-шестерня.cdw
|
колесо.cdw
|
Крышка.cdw
|
листик 2.cdw
|
листик 52.cdw
|
приводной вал.cdw
|
РПЗ.doc
|
Additional information
Contents
Terms of Reference
Mechanism kinematic diagram
Electric motor selection
Determination of the total gear ratio of the drive and its breakdown by stages
Determination of power, torque and speed of each drive shaft
Determination of allowable stresses for calculation of helical cylindrical gear of reduction gear box
Defining Basic Parameters of Closed Helical Cylindrical
transfers
Shaft calculation
Dimensions of structural elements of helical wheels
Calculation of chain transmission
Selection and check of rolling bearings by dynamic lifting capacity
Check calculation of the most loaded shaft for fatigue strength and stiffness
Check calculation of shaft by G-loads
Shaft rigidity check calculation
Selection and calculation of key connections
Literature
Lubrication of gears and bearings
Lubricants in machines are used to reduce wear intensity, reduce friction forces, remove heat from friction surfaces, and also to protect parts from corrosion. The reduction of friction forces due to lubrication provides an increase in the efficiency of the machine, in addition, dynamic loads are reduced, smoothness and accuracy of the machine are increased. We accept liquid industrial oil I30A GOST 2079975. The depth of immersion of gears in oil must be not less than the engagement module and not more than a quarter of the pitch circle of the wheel.
321.cdw
вал-шестерня.cdw
колесо.cdw
Крышка.cdw
листик 2.cdw
листик 52.cdw
приводной вал.cdw
Similar materials
- 15.02.2021