Design of conical-cylindrical reducer
- Added: 30.08.2014
- Size: 584 KB
- Downloads: 0
Description
Project's Content
|
|
Вал промежуточный А3.cdw
|
Колесо зубчатое А3.cdw
|
Крышка глухая А3.cdw
|
Лист 1 А1.cdw
|
Лист 2 А1.cdw
|
Муфта А3.CDW
|
ПЗ.doc
|
Привод А1.cdw
|
РЕФЕРАТ.doc
|
Спецификация привод.spw
|
Спецификация Редуктор.spw
|
Титульник.DOC
|
Additional information
Contents
CONTENTS
Introduction
1. Electric motor selection
2. Kinematic and power calculation of the drive
3. Calculation of gears
4. Tentative calculation of shafts
5. Gear Wheel Design Dimensions
6. Gearbox housing structural dimensions
7. Bearing durability check
8. Selection and inspection of key connections
9. Refined calculation of intermediate shaft
10. Selection of gearbox part fits
11. Selection of couplings
12. Grease Selection
Conclusion
List of literature used
Project Description
The course design contains 4 sheets of drawings of format A1, an explanatory note on 47 sheets, including 12 figures, 10 tables, 3 literary sources.
DRIVE, ELECTRIC MOTOR, REDUCTION GEAR, KINEMATIC CALCULATION, GEAR RATIO, CONICAL TRANSMISSION, GEAR TRANSMISSION, DESIGN CALCULATION, CHECK CALCULATION, SHAFT, GEAR WHEEL, REDUCTION GEAR HOUSING, BEARING, KEY, COUPLING.
The purpose of the project is to develop a drive to a chain suspension conveyor.
During the work on the project, an electric motor was selected, the kinematic and power calculation of the drive was carried out, the calculation of gear gears, gear shafts, the design sizes of gear wheels and the housing were determined, bearings were selected and checked for durability, the strength of key connections was checked, and the lubrication of gear gears and bearings was selected.
As a result of the work, the following were developed: a gearbox assembly drawing, working drawings of gearbox parts, a general view of the drive.
Вал промежуточный А3.cdw
Колесо зубчатое А3.cdw
Крышка глухая А3.cdw
Лист 1 А1.cdw
Лист 2 А1.cdw
Муфта А3.CDW
Привод А1.cdw
Спецификация привод.spw
Спецификация Редуктор.spw