Cradle elevator drive, scheinblite version 11-7
- Added: 11.01.2018
- Size: 302 KB
- Downloads: 1
Description
Explanatory note Shaft Reducer Housing Wheel
Project's Content
|
Kursovoi_774_proekt.docx
|
Koleso.cdw
|
Korpus.cdw
|
reduktor.cdw
|
Val.cdw
|
Additional information
Contents
Terms of Reference
1. Kinematic diagram of machine unit
1.1. Machine unit operating conditions
1.2. Service life of drive device
2. Motor selection, kinematic calculation of drive
2.1 Determination of engine power and speed
2.2 Determination of gear ratio of the drive and its stages
2.3 Determination of power and kinematic parameters of the drive
3. Selection of gear materials and determination of allowable stresses
4. Calculation of closed cylindrical transmission
5. Calculation of open chain transmission
6. Gear shaft loads
7. Design calculation of shafts. Gearbox Sketch Layout
8. Gearbox shaft design diagram
9. Reduction gear box lubrication
10. Fitting and checking of couplings
Literature
1. Kinematic diagram of machine unit
Machine unit operating conditions
The designed machine unit serves as the drive of the cradle elevator and can be used at enterprises in various directions. Drive consists of electric motor whose shaft is connected through elastic clutch to drive shaft of cylindrical reduction gear and open chain plate gear, driven shaft of which is drive shaft of elevator. The designed drive operates in 1 shift in non-revertive mode. The nature of the load is with small fluctuations.
Koleso.cdw
Korpus.cdw
reduktor.cdw
Val.cdw
Similar materials
- 30.08.2014
- 24.04.2014
- 15.12.2014