Conductor design (flow rectifier)
- Added: 09.07.2014
- Size: 312 KB
- Downloads: 1
Description
Project's Content
|
|
|
Записка к оснастке мат.doc
|
Кондуктор мат1 2335.cdw
|
наладка1.cdw
|
раб.чертёж дет.выпр.cdw
|
Спецификация лист 2 выпр.cdw
|
Спецификация лист1выпр.cdw
|
|
Additional information
Contents
Part Assignment and Working Conditions
Calculation of cutting forces per operation + power
Calculation of accessory for clamping force
Calculation of fixture for accuracy
Description of machine tool operation
List of literature used
Part Assignment and Working Conditions
Flow rectifier is intended for oil liquid flow straightening. Operation of flow rectifier: rotating at constant frequency, output
the flow straightener aligns the non-constant flow .
Description of operation of accessory
Installation (removal) of the workpiece.
Blank is installed in conductor plate (2), which is centered relative to housing of accessory (1) by three pins. Quick-release washer (10) is installed on rod (3). The withdrawal is done in reverse order.
Blank clamp.
Compressed air from the system enters the cavity above the piston (cavity A), and the cavity under the piston (cavity B) communicates with the atmosphere. Under the action of compressed air pressure, piston (4) moves downwards. Force is transmitted through rod to quick-detachable washer, by means of which blank is clamped.
Release the workpiece.
Cavity A communicates with atmosphere, and compressed air is supplied to cavity B from system. Piston rises upwards until stop. The workpiece is expanded .
Кондуктор мат1 2335.cdw
наладка1.cdw
раб.чертёж дет.выпр.cdw
Спецификация лист 2 выпр.cdw
Спецификация лист1выпр.cdw