Conductor for drilling of hole on radial drilling machine
- Added: 17.04.2017
- Size: 86 KB
- Downloads: 2
Description
Conductor for drilling hole of diameter 24 on radial drilling machine.
Project's Content
|
|
Кондуктор (спец).cdw
|
|
Кондуктор.cdw
|
КП по ТехОснастке.doc
|
Additional information
Machine Tool Design
1 Design and operating principle of machine tool
For drilling of an opening of Ø24 of mm on radial-drilling operation the conductor whose design is presented on sheet 15.03.05.TO16.123.00SB is designed.
The conductor is designed to install two rods, which are installed on two prisms 3 fixed on plate 1. In axial direction rods rest against wall of conductor plate 2 attached to plate 1. Alignment of rod along eye plane is provided by means of spring-loaded support plate 6, which moves along two guide rods 7. Two rods are clamped in conductor by means of one grip 4 installed on stud 5 by nut 16. Two quick-detachable conductor sleeves 14 are inserted into permanent sleeves 9 pressed into the holes of conductor plate 2 and attached by screws 13. The conductor does not require orientation and is fixed on the table of the 2M55 radial drilling machine by two bolts 10.
Кондуктор (спец).cdw
Кондуктор.cdw
