• RU
  • icon Waiting For Moderation: 9
Menu

Calculation of interference landing scheme

  • Added: 02.06.2015
  • Size: 1 MB
  • Downloads: 0
Find out how to download this material

Description

Calculation of interference landing scheme

Project's Content

icon
icon
icon KOMPAS -- схема посадки с натягом -_Системный вид.pdf
icon колесо.CDW
icon колесо.jpg
icon контроль вала.cdw
icon контроль вала.jpg
icon ПЗ.pdf
icon схема посадки переходной.cdw
icon схема посадки переходной.jpg
icon схема посадки с натягом.cdw
icon схема посадки с натягом.jpg
icon шлицы.cdw
icon шлицы.jpg
icon ПЗ.doc

Additional information

Contents

Contents

Job sheet for coursework

Paper

Contents

Introduction

Designations

Task 1: Select Interference Fit

Task 2: Select transition fit _____________________________

Task 3: Calculate Dimension Chains ________________________________

Task 4: Calculation of Bearing Fits ____________________________

Task 5: Caliber Calculation ______________________________________

Task 6. Calculation of screw joint fit __________________

Task 7. Selection of test complex for gear

Wheels and working drawing development ___________________________

Task 8. Selection of control schemes for error determination

surface locations and shapes ____________________________

List of GOST used for solving problems

List of used literature

Introduction

The goal of solving the problems is a deeper assimilation of the main theoretical positions and acquisition of skills for selecting fits for various joints of parts depending on their technical purpose, as well as improvement of skills for searching and using regulatory documents (GOST, ST CMEA, etc.) and tabular data.

Designations

D (d) - nominal diameter of hole and shaft

Dmax (dmax) - largest limit size of hole and shaft

Dmin (dmin) - smallest limit size of hole and shaft

EI - lower limit deviation of hole

ES- upper limit deviation of hole

ej- lower limit deviation of shaft

es - upper limit deviation of shaft

JT quota tolerance

TD (td) - inlet for manufacturing of hole or shaft

T (SN) - clearance or interference (landing tolerance)

Smax-largest clearance in connection

Smin-smallest clearance in connection

Nmin-least interference in connection

Nmax-highest interference in connection

Eu-mean deviation of hole tolerance field

eu-average deviation of shaft tolerance field

Ncp-Medium Interference

Drawings content

icon колесо.CDW

колесо.CDW

icon контроль вала.cdw

контроль вала.cdw

icon схема посадки переходной.cdw

схема посадки переходной.cdw

icon схема посадки с натягом.cdw

схема посадки с натягом.cdw

icon шлицы.cdw

шлицы.cdw
up Up