Dimensional analysis of the technological process of manufacturing the "Bushing" part

Introduction 

1. Input  

1.1 Part  Drawing

1.2. Development of an operations plan

2. Calculation of linear technological dimensions 

2.1. Construction of a Processing Scheme for Linear Technological Dimensions 

2.2. Construction of graphs of dimensional chains - linear technological and design dimensions.

2.3. Computational equations for solving dimensional chains 

2.4. Calculation of allowances and tolerances

2.5. Calculation of Linear Dimensions by Tabular Method  

2.6. Data Preparation and Calculation of Linear Dimensions on Computers   

2.7. Data Preparation and Calculation of Linear Dimensions on Computer   

2.8.. Data Preparation and Calculation of Linear Dimensions on Computers   

3. Calculation of diametrical technological dimensions  

3.1. Construction of a scheme for processing diametrical technological dimensions 

3.2. Constructing graphs of dimensional chains of eccentricities 

3.3. Calculation of Diametrical Dimensions by Tabular Method 

3.4. Data Preparation and Calculation of Diametrical Dimensions on Computers  

3.5. Data Preparation and Calculation of Diametrical Dimensions on Computers  

3.6 Calculation Results for the Project Task 

Conclusion 

References 

Annex 1. Results of calculations for a design task on a computer for linear dimensions  

Annex 2. Results of calculations for a design task on a computer for linear dimensions  

Annex 3. Results of calculations for a design task on a computer for diametrical dimensions