DEVELOPMENT OF A PROJECT FOR POWER SUPPLY AND INSTALLATION OF ELECTRICAL EQUIPMENT FOR A MACHINE SHOP
- Added: 28.05.2023
- Size: 252 KB
- Downloads: 3
Description
| INTRODUCTION |
| 1 TECHNOLOGICAL PART |
| 1.1 Overview of sources used |
| 1.2 Brief description of the technological process of the object |
1.3 Power supply of the workshop 1.4 Calculation of power and lighting loads of the workshop 1.4.1 For Group A 1.4.2 For Group B 1.5 Selection of the number, power and location of the workshop transformer substation, taking into account the compensation of reactive power 1.5.1 Selection of the number and power of the workshop transformer Substation 1.5.2 Selection of the optimal number of shop transformers 1.5.3 Selection of the location of the workshop transformer substation 1.6 Calculation of the distribution network, selection and calculation of protective devices on the low voltage side 1.6.1 Selection of switchgears 1.6.2 Selection of protection devices 1.6.3 Selection of a circuit breaker to protect the distribution point FP1 and WP2 1.7 Selection of cross-section of wires and cable cores 1.7.1 Selection of wires of the feeding machine position 26 1.7.2 Selection of the cable for the supply of WP1 and WP2 1.8 Calculation of workshop lighting 1.9 Calculation of the grounding device of electrical installations |
| CHAPTER 2 ORGANIZATIONAL PART |
2.1 Development of estimate documentation for the installation of equipment 2.2 Procedure for the application of collections of estimated norms |
| 2.3 Health, safety and environmental protection |
| 2.4 Economic part |
| CONCLUSION |
| LIST OF SOURCES USED |
Project's Content
План цеха.cdw
|
|
однолинейная схема.cdw
|
Диплом.docx
|
Additional information
План цеха.cdw
однолинейная схема.cdw
