Course on architecture - Press-stamping workshop of plastic products
- Added: 14.08.2014
- Size: 984 KB
- Downloads: 0
Description
Total 4 drawing sheets and explanatory note:1.
Project's Content
|
|
курсач.dwg
|
пз(часть1).docx
|
|
пз(часть2).docx
|
|
рамки.docx
|
Additional information
Contents
Introduction
1 Architectural and construction part
1.1 Master Plan
1.2 Volume Planning Solution
1.3 Structural part
1.4 External and internal finishing
1.5 Feasibility Comparison of Design Options
1.6 Calculation of domestic premises
1.7 Specification of prefabricated products
1.8 Bibliography
Introduction
In accordance with the design assignment, a press-stamping workshop for plastic products in Pinsk was designed. Climatic construction area - IIA. The normative value of the snow load of the I snow region is 0.5MPa. Wind load - 0.23MPa. Average outside air temperature as per NSS 2.04.022000 "Construction climatology":
-the coldest days -25 ° С
-the coldest five days -21 ° С
курсач.dwg
